Tricep/Chest Tuesday

1. Position yourself with your back down on a flat bench placing the hands up on the bar using an underhand grip slightly wider than shoulder width apart.
2. After taking a deep breath in, extend the elbows and lift the bar up off the rack until elbows are extended but not locked. Pause for a brief movement as you fully extend your breath.
3. Lower the weight directly down to the chest as you breath inwards, keeping the movement pattern slow and steady.
4. Once just above the chest, pause, and then press directly up again, exhaling your breath.
5. Continue until all reps are completed and then re-rack the barbell.

1. Lie on a flat bench holding a dumbbell in each hand with an overhand grip.
2. Start by holding the dumbbells slightly wider than shoulder width apart above your shoulders. Your palms should be facing forward.
3. Slowly bend your elbows until they are at a 90 degree angle and your upper arms are parallel to the ground.
4. Push the weights up by straightening your arms.
5. As you push the weights up, move your arms in an arc to bring the dumbbells together, until they meet over the center of your chest. Hold for a count of one.
6. Lower the dumbbells by slowly bending your elbows back to 90 degrees.
7. Continue lowering your arms until they are a little lower than parallel to the floor. (Your elbows should be pointing slightly towards the floor and you should feel a stretch in your chest muscles and shoulders.)
8. Repeat

Be sure to concentrate on a balanced movement when lifting the dumbbells. Use both arms equally spaced and moving at the same speed.

1. Place a pair of dumbbells on the floor. Lie on your back in between the dumbbells. Bend your knees and move your feet towards your butt.
2. Grab the dumbbells and hold them above you. Allow your upper arms to remain on the floor. Begin the movement by pushing the dumbbells over your chest. Pause at the top and squeeze your chest muscles.
3. Slowly bring the weights down to the starting position, allowing your arms to rest for a brief moment before beginning the next repetition.

1. Sit on the seat with your upper chest just above the horizontal handles.
2. Push the foot lever until you are able to grasp the lever.
3. Gras the handles using a wide overhand grip and place your elbows out to the sides just below your shoulders.
4. Release the foot lever and press the hand lever out until your arms are fully extended.
5. Return the weight until your chest muscles are slightly stretched.

1. Get into position by placing your hands flat on the floor, directly below your shoulders.
2. Extend your legs out behind you, with only your toes and balls of your feet touching the floor.
3. Hold your body up and keep your back straight by tightening your abdominal muscles.
4. Your neck and head should be bent slightly back.
5. Lower your chest towards the ground by bending your elbows until your chest is just above the ground or you feel a stretching of your chest and shoulders. Hold for a count of one.
6. Press upwards from your chest and shoulders, straightening your arms as you return to the starting position. Hold for a count of one.
7. Repeat.

1. Sit on a pec deck machine with your back flat against the back rest.
2. Grip the handles and make sure your arms are parallel to the floor. If not parallel,adjust the seat or handles accordingly. This is the start position.
3. Exhale and slowly push the handles together  squeezing your chest to the middle as you do so. Hold for a count of one.
4. Inhale as you return to the starting position in a controlled movement.
5. Repeat.

This exercise can be performed using an exercise band or pulleys. There are a variety of  different machines with different placement of your forearms. With these,  place your forearms on the pad, with your elbow bent to 90 degrees. Perform the exercise by squeezing your elbows together.

• Holding a pair of dumbbells, sit on a flat bench and slowly lower yourself back.
• Keep a tight core as you push the dumbbells above your chest. The dumbbells will be facing one another and held together.
• With a slight bend in the elbow, open up your chest and slowly lower the dumbbells to the sides.
• When the dumbbells are parallel with the ground, pause, and return to the starting position.

1. Stand between two cable stations with the dumbbell grip handles attached to the high pulleys on each side of you.
2. Hold the handles with an overhand grip. Your arms should be outstretched.
3. Bend your knees and hips slightly so that you are leaning forward, but not too far.
4. Bend your elbows slightly and rotate your shoulders in towards the centre of your chest a little. Your elbows should be slightly behind you.
5. Use a hugging motion, keeping your elbows in a fixed, bent position to bring the grip attachments together in front of your chest.
6. Slowly return to the starting position until you feel a slight stretch in your chest muscles.
7. Repeat.

1. Attach a rope to the bottom pulley of a cable station.
2. Grip the rope with both hands using a neutral grip. Turn your body away from the cable station.
3. Fully extend your arms until your hands are directly above your head pointing to the ceiling.
4. Keep your elbows  close to your head. This is the start position.
5. Slowly lower the rope behind your head, keeping your upper arms stationary, inhaling as you do so.
6. When your triceps are fully extended, hold for a count of one while squeezing your triceps.
7. Return to the starting position by flexing your triceps  and extending your arms. Exhale as you do so.
8. Repeat.

This exercise can be performed  seated on a plain bench, or one that has a back support You  can also use a single dumbbell instead of the rope.

1. Sit on a bench with back support.
2. Grip a dumbbell at one end using both hands. Your palms should be facing inward.
3. Hold the dumbbell overhead with your arms fully extended.  This is the the start position.
4. Keep your upper arms close to your head (biceps roughly level with your temples) and near to 90degrees to the floor.
5. Moving only your forearms, lower the dumbbell in a smooth arc behind your head until your forearms and biceps touch. Hold for a count of one.
6. Return to the start position by using the triceps to extend your arm and raise the dumbbell. Exhale as you do this.
7. Repeat.

This exercise can be performed standing. However, it places an extra strain on your back so is not recommended for people with lower back problems. You can also perform this exercise using an EZ bar or straight bar with a close grip behind your head, palms facing forward.

1. Begin the movement by stepping on to a resistance band with your feet at shoulder-width, toes pointed slightly out.
2. Push the handles of the band overhead while keeping a slight bend in the elbow. Brace your abdominals and do not arch your back.
3. Slowly lower your hands behind your head using only the forearms. The upper arms will stay in place with the elbow pointed up.
4. Push the handles back up, focusing the tension in the triceps.

1. Set a barbell in a weight rack at the low end of a decline bench, making sure it is at a height you can reach without fully extending your arms.
2. Secure your feet under the stirrup, bar or strap at the high end of the bench and lie flat on your back with the rack slightly behind you.
3. Using an overhand grip, grip the bar with your hands slightly wider than your shoulder width apart.
4. Push up to lift the bar from the rack and hold it directly over you with your arms locked.
5. Bend your elbows to slowly lower the barbell until it slightly touches your chest, inhaling as you do so.
6. Drive the weight back up by contracting your pec muscles and return to the start position, exhaling as you do so.
7. At the top of the movement, lock your arms and squeeze your chest muscles.

If you are new at this exercise, you should use a spotter. If no spotter is available, then be conservative with the amount of weight used. Do not  let the bar drift too far forward, it should touch down your lower chest only. Don't bounce the weight off your chest. Keep full control of the barbell at all times. When performing this exercise, use a 2:1:1 count. That is a count of two on the downward movement. Pause for a count of one. A count of one one the upward movement. You can also use dumbbells or exercise bands to perform this exercise.

1. Place a pair of dumbbells on the floor next to a decline bench. Secure yourself in the bench. Pick up dumbbells and hold them above you with a slight bend in the elbow.
2. Keeping the dumbbells in line with your chest, slowly open up your arms to the sides.
3. Stop when your upper arms are parallel with the floor.
4. Squeeze your chest muscles and slowly return to starting position. Repeat.

1. Adjust the pulley lever to be below you. Stand in the center of the pulley machine while holding both handles. Brace your abdominals and take a step forward.
2. With your chest up, bring the handles up and to the front of your body. The handles will meet at shoulder height.
3. Pause to feel the contraction in your chest then slowly lower the handles to the starting position.

• Holding a pair of dumbbells, sit on a flat bench and slowly lower yourself back.
• Keep a tight core as you push the dumbbells above your chest. The dumbbells will be facing one another and held together.
• With a slight bend in the elbow, open up your chest and slowly lower the dumbbells to the sides.
• When the dumbbells are parallel with the ground, pause, and return to the starting position.

1. Lying on a flat bench, grab the barbell with an underhand grip. Hands will be shoulder-width apart. With a tight core and flat back, lift the barbell above, bringing it to chest level.
2. Slowly lower the bar until your upper arms are parallel with the floor. Pause, contract, and return to the starting position.

1. Position yourself with your back down on a flat bench placing the hands up on the bar using an underhand grip slightly wider than shoulder width apart.
2. After taking a deep breath in, extend the elbows and lift the bar up off the rack until elbows are extended but not locked. Pause for a brief movement as you fully extend your breath.
3. Lower the weight directly down to the chest as you breath inwards, keeping the movement pattern slow and steady.
4. Once just above the chest, pause, and then press directly up again, exhaling your breath.
5. Continue until all reps are completed and then re-rack the barbell.

1. Sit on a bench with back support.
2. Grip a dumbbell at one end using both hands. Your palms should be facing inward.
3. Hold the dumbbell overhead with your arms fully extended.  This is the the start position.
4. Keep your upper arms close to your head (biceps roughly level with your temples) and near to 90degrees to the floor.
5. Moving only your forearms, lower the dumbbell in a smooth arc behind your head until your forearms and biceps touch. Hold for a count of one.
6. Return to the start position by using the triceps to extend your arm and raise the dumbbell. Exhale as you do this.
7. Repeat.

This exercise can be performed standing. However, it places an extra strain on your back so is not recommended for people with lower back problems. You can also perform this exercise using an EZ bar or straight bar with a close grip behind your head, palms facing forward.

1. Attach a rope to the bottom pulley of a cable station.
2. Grip the rope with both hands using a neutral grip. Turn your body away from the cable station.
3. Fully extend your arms until your hands are directly above your head pointing to the ceiling.
4. Keep your elbows  close to your head. This is the start position.
5. Slowly lower the rope behind your head, keeping your upper arms stationary, inhaling as you do so.
6. When your triceps are fully extended, hold for a count of one while squeezing your triceps.
7. Return to the starting position by flexing your triceps  and extending your arms. Exhale as you do so.
8. Repeat.

This exercise can be performed  seated on a plain bench, or one that has a back support You  can also use a single dumbbell instead of the rope.

1. Begin the movement by stepping on to a resistance band with your feet at shoulder-width, toes pointed slightly out.
2. Push the handles of the band overhead while keeping a slight bend in the elbow. Brace your abdominals and do not arch your back.
3. Slowly lower your hands behind your head using only the forearms. The upper arms will stay in place with the elbow pointed up.
4. Push the handles back up, focusing the tension in the triceps.

1. Standing between the bars of a dip station, grip the bars with an overhand grip,keeping your elbows tucked in close to your body.
2. Allow your body weigh to hang so it is being supported by your arms and shoulders. Keep your hips straight.
3. Push down through your palms with your arms, lifting your body up until your arms are almost straight. (Do not lock your elbows)
4. Lower your body by slowly bending your elbows and continue down until you feel a slight stretch in your shoulders.
5. Pause, then push yourself back to the starting position.
6. Repeat.

By keeping your back straight and not leaning forward, you will work your triceps harder.If you wish to work on your chest leaning forward puts more emphasis on your pecs. As your strength increases, you can add weight by using a dip belt.

1. Begin by using the weight stack to offset your bodyweight on an Assisted Dip machine. Now, position your knees securely on the padded surface while holding on to the bars on either side of you.
2. Before lowering yourself, make sure that your core is tight and that your elbows are pointing directly behind you. Slowly, lower yourself until your upper arms are parallel with the floor.
3. Push yourself back to the starting position and squeeze your triceps at the top. Lower yourself again slowly for the next repetition.

1. Sit at the Triceps Dip machine but make sure to brace your core throughout the movement. Place your hands on the bar with your elbows pointing behind you. Your arms will make a 90 degree angle.
2. Slowly push down on the bars, focusing all the movement in your triceps.
3. When you reach the bottom, pause and do not lock out your elbows. Slowly return to the starting position but do not let the weight touch the stack.

1. Sit on a chair with your hands either next to your hips or slightly under the hips.
2. Lift up onto your hands and bring your hips forward.
3. Bend your elbows and lower your hips down, keeping shoulders down and hips close to the chair.
4. Push back up but don’t lock your elbows and repeat.

1. Set up 2 flat benches opposite each other. They should be roughly the distance of your hips to the floor apart.
2. Stand with your back to one bench,facing the other, then crouch down placing your palms behind you on the edge of the bench. Your arms should be fully extended at shoulder width, with your fingers facing forward.
3. Place the heels of your feet on the other bench. Keep your legs fully extended.
4. Have a spotter place a barbell weight plate or dumbbell on your lap. This is the start position.
5. Slowly lower yourself down by bending your elbows,until they are at 90 degrees or slightly less. Hold for a count of one.
6. Return to the starting position by pushing yourself up using only your triceps to straighten your arms. Hold then repeat

You will need a spotter to help you with this exercise. Trying to place the weight in your own lap once in position can cause instability and increase the risk of injury. Have your spotter remain with you throughout your set to ensure the weights don't slide off causing injury.

1. Sit on a chair with your hands either next to your hips or slightly under the hips.
2. Lift up onto your hands and bring your hips forward.
3. Bend your elbows and lower your hips down, keeping shoulders down and hips close to the chair.
4. Push back up but don’t lock your elbows and repeat.