Intermediate Resistance Push

1. Set up a bench or stable elevated surface. Begin with both hands on the bench at shoulder-width or just outside of shoulder-width.
2. Place your feet straight behind you while you tighten your abs and engage the hips. Your hips should not dip or elevate too high during the movement.
3. Slowly lower yourself towards the bench. Once your upper arms are parallel with the floor, pause, and return to the starting position.

1. Set a barbell in a weight rack at the low end of a decline bench, making sure it is at a height you can reach without fully extending your arms.
2. Secure your feet under the stirrup, bar or strap at the high end of the bench and lie flat on your back with the rack slightly behind you.
3. Using an overhand grip, grip the bar with your hands slightly wider than your shoulder width apart.
4. Push up to lift the bar from the rack and hold it directly over you with your arms locked.
5. Bend your elbows to slowly lower the barbell until it slightly touches your chest, inhaling as you do so.
6. Drive the weight back up by contracting your pec muscles and return to the start position, exhaling as you do so.
7. At the top of the movement, lock your arms and squeeze your chest muscles.

If you are new at this exercise, you should use a spotter. If no spotter is available, then be conservative with the amount of weight used. Do not  let the bar drift too far forward, it should touch down your lower chest only. Don't bounce the weight off your chest. Keep full control of the barbell at all times. When performing this exercise, use a 2:1:1 count. That is a count of two on the downward movement. Pause for a count of one. A count of one one the upward movement. You can also use dumbbells or exercise bands to perform this exercise.

1. Place a pair of dumbbells on the floor next to a decline bench. Secure yourself in the bench. Pick up dumbbells and hold them above you with a slight bend in the elbow.
2. Keeping the dumbbells in line with your chest, slowly open up your arms to the sides.
3. Stop when your upper arms are parallel with the floor.
4. Squeeze your chest muscles and slowly return to starting position. Repeat.

1. Hold a kettlebell in your left hand and bring it to the center of your body. Throughout this movement, be sure to keep your abdominals braced and your gaze straight ahead.
2. Begin the movement by bending at the knees then driving yourself up as you pull the kettlebell up. At the top, rotate the wrist so the kettlebell flips to the other side of your hand.
3. Bend at the knees again with a slight lowering of the hips then drive yourself back up to create momentum. Push the kettlebell straight overhead. Carefully bring the weight down and repeat.

1. Stand over a dumbbell with your feet placed slightly wider than hip width apart either side of the dumbbell.
2. Squat down and take a firm grip of the dumbbell; ensure that your shoulders are positioned upright, keeping your back straight and eyes straight ahead.
3. Explosively lift the dumbbell by extending your hips from the squatting position and allow the dumbbell to travel along upward and close to your body.
4. As the dumbbell reaches your hip level, shrug your lifting shoulder and pull the dumbbell upwards keeping the same line of trajectory if viewed from the side.
5. Bending your working elbow and allowing the dumbbell to extend overhead, slightly squat your body below so that your position is semi-squatted with your working arm fully extended above your head.
6. Maintaining a solid grip on the now overhead dumbbell, drive your feet into the floor and rise upwards from the semi-squatting position to complete the lift.

This exercise is a complicated explosive lift. If attempting for the first time, start with a light dumbbell for form practice. Ideally, do so with a qualified trainer present.

• With dumbbells at your sides, stand with your feet slightly wider than shoulder-width apart and fee pointing slightly outward. Look straight ahead.
• Squat down until your upper legs are parallel with the floor by bending your knees, keep your back straight.
• With an explosive but controlled movement, push up through your heels and press the dumbbells above your head as you return to standing position.
• Still standing, slowly lower the dumbbells down to your chest and then down to your sides by extending your arms.
• Repeat.

• With dumbbells at your sides, stand with your feet slightly wider than shoulder-width apart and fee pointing slightly outward. Look straight ahead.
• Squat down until your upper legs are parallel with the floor by bending your knees, keep your back straight.
• With an explosive but controlled movement, push up through your heels and press the dumbbells above your head as you return to standing position.
• Still standing, slowly lower the dumbbells down to your chest and then down to your sides by extending your arms.
• Repeat.

1. Shoulder-width stance. Tight core and flat back. Bend at the knees and hips. Lower yourself. Arms fully extended. Chest up and gaze straight ahead.
2. Bring knees in and shoulders up. Drive hips forward. Keep the bar close to your body. Forcefully exhale and perform a full extension of the knees and hips.
3. Use the momentum to bring elbows high. Rotate your elbows around and under the bar. Rack the bar across the front of your shoulders.
4. Press the barbell above your head. Lower the bar.

• With water bottles at your sides, stand with your feet slightly wider than shoulder-width apart and feet pointing slightly outward. Look straight ahead.
• Squat down until your upper legs are parallel with the floor by bending your knees, keep your back straight.
• With an explosive but controlled movement, push up through your heels and press the water bottles above your head as you return to standing position.
• Still standing, slowly lower the water bottles down to your chest and then down to your sides by extending your arms.
• Repeat.

1. Place a kettlebell between your feet.
2. Stand with your feet slightly wider than shoulder width apart.
3. Bend your knees and push your hips back,bending at the waist while keeping your back straight.
4. Grip the kettle bell with an overhand grip.
5. Keeping your neck and head straight, swing the kettlebell back between your legs.
6. Once the kettlebell is behind you, immediately reverse the direction and drive forward with your hips and knees, forcing the kettlebell upward.
7. When the kettlebell reaches shoulder level, rotate your hand and push straight up, using your momentum.
8. Use your body’s downward momentum to receive the weight as it comes back down.
9. Return to the start position.
10. Repeat until all the repetitions for one arm are completed, then switch.

The exercise can be performed continuously, using the downward momentum to swing the kettlebell backwards. However for maximum benefit, it is better to follow the outline described.

1. Stand over a dumbbell with your feet placed slightly wider than hip width apart either side of the dumbbell.
2. Squat down and take a firm grip of the dumbbell; ensure that your shoulders are positioned upright, keeping your back straight and eyes straight ahead.
3. Explosively lift the dumbbell by extending your hips from the squatting position and allow the dumbbell to travel along upward and close to your body.
4. As the dumbbell reaches your hip level, shrug your lifting shoulder and pull the dumbbell upwards keeping the same line of trajectory if viewed from the side.
5. Bending your working elbow and allowing the dumbbell to extend overhead, slightly squat your body below so that your position is semi-squatted with your working arm fully extended above your head.
6. Maintaining a solid grip on the now overhead dumbbell, drive your feet into the floor and rise upwards from the semi-squatting position to complete the lift.

This exercise is a complicated explosive lift. If attempting for the first time, start with a light dumbbell for form practice. Ideally, do so with a qualified trainer present.

• Position a flat bench below the barbell of a Smith Machine.
• Lie on the bench face up and place your hands slightly outside of shoulder width on the barbell.
• Push the barbell up then immediately rotate it so the hooks turn out. Do not flare out your elbows.
• Slowly lower the barbell and pause just above your chest.
• Push the barbell back up to the starting position.
• Repeat the movement.

1. Lie on a flat bench holding a dumbbell in each hand with an overhand grip.
2. Start by holding the dumbbells slightly wider than shoulder width apart above your shoulders. Your palms should be facing forward.
3. Slowly bend your elbows until they are at a 90 degree angle and your upper arms are parallel to the ground.
4. Push the weights up by straightening your arms.
5. As you push the weights up, move your arms in an arc to bring the dumbbells together, until they meet over the center of your chest. Hold for a count of one.
6. Lower the dumbbells by slowly bending your elbows back to 90 degrees.
7. Continue lowering your arms until they are a little lower than parallel to the floor. (Your elbows should be pointing slightly towards the floor and you should feel a stretch in your chest muscles and shoulders.)
8. Repeat

Be sure to concentrate on a balanced movement when lifting the dumbbells. Use both arms equally spaced and moving at the same speed.

1. Position yourself with your back down on a flat bench placing the hands up on the bar using an underhand grip slightly wider than shoulder width apart.
2. After taking a deep breath in, extend the elbows and lift the bar up off the rack until elbows are extended but not locked. Pause for a brief movement as you fully extend your breath.
3. Lower the weight directly down to the chest as you breath inwards, keeping the movement pattern slow and steady.
4. Once just above the chest, pause, and then press directly up again, exhaling your breath.
5. Continue until all reps are completed and then re-rack the barbell.

1. Align a Smith Machine barbell so that it is level with your shoulder height. Stand at the barbell and brace your core. Make sure your back is flat and your chest is up.
2. Position your hands at shoulder-width on the barbell. Unlatch the barbell and press it above your head. Maintain a slight bend in the elbows throughout.
3. Slowly lower the barbell down, immediately going into the next repetition.

1. Place a bench with a back support inside a squat rack and set up a barbell at a height that is just above your head.
2. Grip the barbell with an overhand grip.
3. Space your hands out so that your elbows are bent at 90 degrees.
4. Lift the bar to around shoulder level by extending your arms.  This is the start position.
5. Inhaling, lower the bar  to your shoulders slowly.
6. Hold for a count of one while squeezing your shoulder muscles.
7. Push the barbell back to the start position as you exhaling as you do so..
8. Repeat for the recommended amount of repetitions.

This exercise can also be performed standing.

1. Sit on a military press bench or bench that has a back support, holding a dumbbell in each hand with an overhand grip.
2. Place the dumbbells on top of your thighs with your palms facing down.
3. Raise the dumbbells to your shoulders.
4. Rotate your wrists so that the palms of your hands are facing away from you. This is the start position.
5. As you exhale,  push the dumbbells up and over your head by extending your arms until the dumbbells touch at the top of the movement.
6. Pause for a count of one.
7. Slowly return to the start position inhaling as you do so.
8. Repeat.

This exercise can be performed standing or sitting on  flat bench. For people with lower back problems, the version described is better.

1. Using a T-Bar, load the amount of weight you’d like to work with (start out lighter to master the form before increasing the load).
2. Grip the top of the barbell so that your hands overlap, and your palms are facing inward.
3. Squat so that your knees are at a 90 degree bend with the top of the barbell almost resting on your chest. Make sure your elbows are low and close to your body and not flaring out.
4. With an explosive movement, push through your legs and drive the end of the barbell away from your body.

1. Stand with your feet shoulder-width apart with dumbbells above your shoulders.
2. Squat down keeping your back flat and your knees over your toes.
3. Push through your heels to return to standing while pressing the dumbbells overhead with arms fully extended.
4. Return to starting position and repeat.

1. Clean two kettlebells to your shoulders. Clean the kettlebells to your shoulders by extending through the legs and hips as you pull the kettlebells towards your shoulders. Rotate your wrists as you do so. This will be your starting position.
2. Begin to squat by flexing your hips and knees, lowering your hips between your legs. Maintain an upright, straight back as you descend as low as you can.
3. At the bottom, reverse direction and stand by extending your knees and hips and pushing down through your heels. As you do so, press both kettlebells overhead by extending your arms straight up, using the momentum from the squat to help drive the weights upward.
4. As you begin the next repetition, return the weights to the shoulders.

1. Begin the movement by stepping on to a resistance band with your feet at shoulder-width, toes pointed slightly out.
2. Bring your hands to your shoulders, keeping the handles of the band behind your shoulders. Brace your core and keep your chest up.
3. Bend first at the knees then at the hips. Lower yourself until your thighs are parallel with the floor. Return to the starting position.
4. When you reach the top, push the resistance bands overhead. Slowly lower your hands and repeat the entire movement.

1. Holding a dumbbell in each hand,stand with your feet shoulder width apart.
2. The dumbbells should be resting on your thighs with your palms facing in.
3. Lift the dumbbells straight up in single smooth movement until they are just below your chin making sure to keep your shoulders back and your elbows out.
4. At the top of the movement, flex or squeeze your biceps and forearms. Hold for a count of one.
5. Return to the starting position slowly to keep tension on the muscles.
6. Repeat.

This exercise can be performed using a barbell,EZ bar or a cable station with a straight bar or EZ bar attachment.

1. Stand with your back straight, holding a barbell with an overhand grip slightly less than shoulder width apart.
2. The bar should be level with the tops of your thighs.
3. Keep your arms extended with a slight bend at the elbows. This is the start position.
4. Exhale and using the sides of your shoulders lift the bar.
5. As you do so, raise your elbows up and out to the side.
6. Keep the bar close to your body as you raise it.
7. Continue  lifting the bar until it is just below your chin. Pause for a count of one.
8. Return to the start position in a single smooth movement. Inhale as you do so.
9. Repeat.

This exercise can be performed using a straight bar attached to a low pulley or using dumbbells.

1. Attach a straight bar to the low pulley on the cable station.
2. Stand facing the station with your feet shoulder width apart either side of the pulley.
3. Grip the bar with an overhand grip, with your hands shoulder width apart and arms fully extended.
4. Keep your shoulders back.
5. Raise the bar straight up in one smooth movement, until it is just below your chin.
6. Hold for a count of one while squeezing your biceps and forearms.
7. Slowly lower to the start position and repeat.