Hams and Glutes

1. Stand up straight while holding two dumbbells. Maintain a tight core and flat back as you carefully place your right foot on top of a bench behind you with toes facing down. 
2. Bend at the front knee as you drop the back knee, maintaining perfect form. Front knee should not go over the toes.
3. Allow your thigh to come to parallel with the floor.
4. Pause then slowly return to the starting position without locking out your knee.
5. Repeat then switch sides once set is complete.

1. Stand straight with your feet hip width apart, arms fully extended and your hands by your sides.
2. Raise your left foot from the floor, extending your leg out in front of you.
3. As you do so, raise both arms out in front of you in a smooth arc for balance. This is the start position.
4. In a controlled movement, lower your body toward the floor by bending your right knee while pushing your hips back as if sitting down in a chair.
5. Continue this downward movement until your right thigh is parallel to the floor.
6. Hold for a count of one.
7. Return to the start position by pushing down through your right heel and straightening your leg. Lower your arms to the start position as you do so.
8. Repeat.

Beginner – this exercise can be completed by placing your hand on a chair, bench, parallel bar or other support to one next to you. Advanced – this exercise can be completed holding dumbbells down by your side, or a kettlebell to your chest to add resistance.

1. Holding a dumbbell in each hand, stand with your feet shoulder width apart.
2. Keep your shoulders back. And your back straight.
3. Take a long stride forward with your right leg. Your right foot should be in a position, that when you bend your right knee, your upper and lower leg form a 90 degree angle.
4. Slowly bend both your knees, to lower your hips until your left (rear) knee is just above the floor. Hold for a count of one.
5. Return to the start position by slowly straightening your legs and raising your body back to a standing position.
6.  Complete all the repetitions for one set full set, then switch legs, or you can alternate between legs for each rep.

Do not let your knee travel past your toes in the down position as this can cause instability and injury.

1. Hold a kettlebell by the handle in one hand using a neutral grip.
2. Stand on the leg that is on the same side that you are holding the kettlebell.This is the start position.
3. Bending that knee slightly, bend at the hip, and extend your free leg behind you for balance.
4. Continue lowering the kettlebell until your torso is parallel to the ground.
5. Return to the upright position in a smooth movement.
6. Repeat.

1. Stand tall with a tight core while holding a pair of dumbbells. Keeping your chest up and your gaze straight ahead, shift all of your bodyweight to your left foot. Bend the right knee, allowing the right foot to lift off the ground.
2. Maintaining a flat back, tilt your upper body forward. Do not allow the dumbbells to pull you down. Control your descent. Simultaneously, allow the right foot to counterbalance the shift in weight.
3. Feel the contraction in your hamstrings and pause once your upper body is parallel with the ground. Slowly return to the starting position.

1. Position yourself on all fours on a mat with your palms flat and shoulder-width apart. Place your knees hip-width apart and bend them at a 90 degree angle.
2. Try to relax your core so that your back and abs are in a natural position.
3. Maintain this posture as you raise your right knee and bring it as close to your chest as you can.
4. Now raise your right thigh out to the side, keeping the hips still.
5. Kick your raised leg straight back slowly until it is in line with your torso.
6. Reverse the movement to return to the starting position.

1. Lie on your right side on top of a yoga mat or other soft surface.
2. Brace your core and make sure your body is in a straight line. Keep your right hand on the ground and your left hand on your hip.
3. Slowly lift the left leg into the air, keeping it straight during the exercise.
4. Slowly lower your left leg. Complete the set then repeat with the other leg.

1. Stand with your feet shoulder width apart while holding a light dumbbell to your chest. You should hold the dumbbell by one end between your hands, with the other end extending down your torso. This is the start position.
2. Squat down keeping your slightly arched and pushing your hips back.
3. Continue down until your thighs are parallel to the floor.
4. Hold for a count of one.
5. Return to the start position.
6. Repeat.

This exercise can also be performed with a kettlebell.

1. Stand up straight with a tight core and flat back.
2. Position your feet wider than shoulder-width. Your toes should be facing out diagonally.
3. Holding a dumbbell with both hands in front of you, look straight ahead and bend at the knees while driving your hips backward. Your knees should be following your toes in a diagonal line.
4. Complete this wide stance squat by having your thighs come parallel with the ground.
5. Pause and slowly return to the starting position without locking your knees.
6. Repeat.

1. With your feet shoulder-width apart, stand with dumbbells as your sides with your palms facing each other.
2. Keeping your back straight and facing forward, squat down until your thighs are parallel to the floor.
3. Pause for one second.
4. Pushing up from your heels, raise back up to starting position and repeat.

1. Place your back flat against the back pad of the hack machine and position your shoulders under the shoulder pads.
2. Place your legs in a shoulder width stance with your toes pointed out slightly.
3. Grip the side handles of the machine and disengage the safety bars.
4. Straighten your legs, but do not lock your knees. This is the start position.
5. Inhale as you slowly lower the weight by bending your knees.
6. Continue down until the angle between your upper legs and your calves is slightly less than 90-degrees. Your outer knee should be in line with your toes. Do not extend your knees past your toes. Hold for a count of one.
7. Return to the start position by pushing down through your heels and extending your legs, exhaling as you do so. When you reach the starting position,hold for a count of one.
8. Repeat

1. Sit down on a leg press machine and place your legs on the platform directly in front of you at shoulder width.
2. Lower the safety bars holding the weighted platform  and press the platform all the way up until your legs are fully extended in front of you bot do NOT lock your knees. Your torso and legs should be at a 90degree angle to each other. This is the start position.
3. Inhaling, slowly lower the platform until your upper and lower legs form a 90-degree angle. Pause for a count of one,
4. Return to the starting position by pushing through the heels of your feet, engaging your quadriceps. Exhale as you do so.
5. Repeat.
6. After completing the desired number of repetitions, make sure you lock the safety pins of the machine before alighting.

Always check to make sure that when you re-rack the weight the platform is securely locked.

1. Begin by positioning a barbell at or just below shoulder level in the squat rack. Behind the squat rack, place a tall wooden box or chair. Place yourself underneath the barbell. Make sure the bar is across your upper traps and NOT on your neck.
2. Place your feet outside of shoulder-width with your toes pointed slightly out. Brace your core and keep your chest up.
3. Bend at the knees as you drive your hips back. Lower yourself slowly until your butt touches the box. Pause then drive your hips forward to return to the starting position.

1. Adjust the seated leg curl machine to position the footpad just above your heels.
2. Sit upright and engage your abs as you position your legs in front of you.
3. Begin to curly your legs back slowly towards you and flex your calf muscles as you do so.
4. Return to the starting position by extending the legs in front of you again.

Tip: Try not to swing the weight or execute the movement too quickly.

1. Lie face down on a leg curl machine and lock your heels under the foot pad. Make sure your legs are fully extended and the foot pads are resting on the back of your ankles.
2. If the machine is equipped with handles, grip them. If not, grip the front of the pad you are lying on.
3. Remaining flat on the bench, with no arching of your spine, curl your legs up in a smooth arcing motion by bending your knees until your hamstrings are fully contracted. Hold for a count of one.
4. Slowly lower your legs to the starting position in a smooth arcing motion.
5. Repeat

Don't use so much weight for this exercise that you need to swing or jerk the weight up. Doing so can cause injury to your lower back and / or hamstrings. Start with a lower weight until your strength increases.

1. Begin with a light weight and stand facing the machine. Position one leg for the lift by hooking it under the weight pad.
2. Make sure the pads are in a comfortable position around your ankle in order to involve the heel in the movement. Don’t position the pads too high on the calf.
3. Grab hold of the support handles.
4. Flex your knee and lift the pad upwards as far as you can towards your buttocks as you exhale.
5. Lower the leg to the starting position.

1. Lie on the ground with a TRX Suspension Strap at your feet. Lift both your feet into the strap, making sure they are secure. Tighten your core and place your hands at your sides.
2. Drive your hips up while maintaining a straight line with your body. Curl your feet in, moving them towards your butt. Maintain balance with your hands on the ground.
3. Once your feet reach your butt, slowly extend your feet back to the starting position. Do not allow your hips to drop. Contract the core during the entire movement.

1. Stand up straight with a tight core and flat back.
2. Position your feet wider than shoulder-width. Your toes should be facing out diagonally.
3. Holding a dumbbell with both hands in front of you, look straight ahead and bend at the knees while driving your hips backward. Your knees should be following your toes in a diagonal line.
4. Complete this wide stance squat by having your thighs come parallel with the ground.
5. Pause and slowly return to the starting position without locking your knees.
6. Repeat.

1. Set a barbell on a rack at your shoulder height.
2. Step under the bar and rest the back of your shoulders against the bar. Do not put the bar on your neck.
3. Hold on to the bar using an overhand grip so that your palms are facing forward.
4. Lift the barbell off the rack by pushing up with your legs while straightening your torso.
5. Step away from the rack and position your legs in a wider than shoulder width position and with your toes slightly pointed out.
6. Keep your head up and look straight ahead at all times, as looking down will put you off balance.
7. Ensure your back is straight. This is the start position.
8. As you inhale, slowly lower the bar by bending your knees while keeping a straight posture with your head up.
9. Continue down until the angle between you upper legs and calves is slightly less than 90-degrees . As a guide, the front of your knees should be in line with your toes. Do not allow your knees to extend out beyond your toes.
10. Hold for a count of one.
11. As you exhale, raise the bar back to the start position, by pushing through your heels as you straighten your legs.
12. Pause for a count of one.
13. Repeat.

This is an exercise which carries some risk. If you have back issues, substitute this exercise for the dumbbell squat or leg press instead. Never slouch your back forward as this can cause back injury. This exercise is best performed inside a squat rack for safety purposes.

1. With your feet shoulder-width apart, stand with dumbbells as your sides with your palms facing each other.
2. Keeping your back straight and facing forward, squat down until your thighs are parallel to the floor.
3. Pause for one second.
4. Pushing up from your heels, raise back up to starting position and repeat.

1. Sit down on a leg press machine and place your legs on the platform directly in front of you at shoulder width.
2. Lower the safety bars holding the weighted platform  and press the platform all the way up until your legs are fully extended in front of you bot do NOT lock your knees. Your torso and legs should be at a 90degree angle to each other. This is the start position.
3. Inhaling, slowly lower the platform until your upper and lower legs form a 90-degree angle. Pause for a count of one,
4. Return to the starting position by pushing through the heels of your feet, engaging your quadriceps. Exhale as you do so.
5. Repeat.
6. After completing the desired number of repetitions, make sure you lock the safety pins of the machine before alighting.

Always check to make sure that when you re-rack the weight the platform is securely locked.

1. Stand tall against a wall with your head and back touching the wall.
2. Position your feet so that they are shoulder-width apart and a few inches away from the wall.
3. Rest your arms at your sides.
4. Bend your knees and lower into a squat position until your thighs are parallel to the floor and hold the position
5. Return to starting position by straightening your knees and standing tall again.

1. Place your feet at shoulder-width or just outside of shoulder-width. Turn your toes out slightly. Brace your core and keep your chest up.
2. Swing your arms up to shoulder level as you slowly bend your knees and push your hips backward. Lower yourself until your thighs are parallel with the ground.
3. Pause and stay in this position for as long as you can. Return to the starting position by dropping your arms and push your hips forward.